The Rolls-Royce Eagle was the first aircraft engine to be developed by Rolls-Royce Limited. Introduced in 1915 to meet British military requirements during World War I, it was used to power the Handley Page Type O bombers and a number of other military aircraft. The Eagle was the first engine to make a non-stop trans-Atlantic crossing by aeroplane when two Eagles powered the converted Vickers Vimy bomber on the transatlantic flight of Alcock and Brown in June 1919.

Background

At the outbreak of World War I in August 1914, the Royal Aircraft Factory asked Rolls-Royce to develop a new 200 hp air-cooled engine. Despite initial reluctance, they agreed, on condition that it be cooled by water rather than by air, which was the company's area of expertise.

Design and development

Development of the new 20 litre engine was led by Henry Royce from his home in Kent. Based initially on the 7.4 litre 40/50 Rolls-Royce Silver Ghost engine, and drawing also on the design of a 7.2 litre Daimler DF80 aero engine used in a 1913 Grand Prix Mercedes that had been acquired, the power was increased by doubling the number of cylinders to twelve and increasing their stroke to 6.5 in, although their bore remained at 4.5 in of the 40/50. The engine was also run faster, and an epicyclic reduction gear was designed to keep the propeller speed below 1,100 rpm. To reduce inertia and improve performance the valvetrain design was changed from sidevalves to a SOHC design, closely following the original "side-slot" rocker arm design philosophy used on the contemporary German Mercedes D.I, Mercedes D.II and Mercedes D.III straight-six aviation powerplants. The engineering department of the Royal Naval Air Service (RNAS) played a key role in the success of the engine by directing the car designer W.O. Bentley, who had enlisted in the Royal Navy, to place his expertise in the design of aluminium pistons at the service of Rolls-Royce. This gave significant weight saving to the Eagle and contributed to its excellent performance. On 3 January 1915 the Admiralty ordered twenty-five of the new engines. The Eagle first ran on a test bed at Rolls-Royce's Derby works in February 1915, producing 225 hp at 1,600 rpm. This was quickly increased to 1,800, then in August 1915 to 2,000 rpm where it produced 300 hp. After further testing, it was decided to approve the engine for production at 1,800 rpm and 225 hp; 1,900 rpm was allowed for short periods. The engine first flew on a Handley Page O/100 bomber in December 1915, the first flight of a Rolls-Royce aero engine. The Eagle was developed further during 1916 and 1917, with power being progressively increased from 225 hp to 266 hp, followed by 284 hp, and then 322 hp, and finally 360 hp by February 1918 by which time eight Eagle variants had been produced. Throughout World War I Rolls-Royce struggled to build Eagles in the quantities required by the War Office, but the company resisted pressure to license other manufacturers to produce it. The fears of Rolls-Royce that the engine's much admired quality would be compromised by other manufacturers is often given as an explanation for this resistance, but the commercial terms sought by Rolls-Royce for licence production were so restrictive that other manufacturers - apart from Brazil Straker - refused to accept them. When the Ministry of Munitions took over coordination of aircraft production in 1917, Sir William Weir declined to intervene in the company's commercial strategy, even though success of the engine owed much to the technology transfer directed by the RNAS. He preferred to support untested engines using cast aluminium components like the Siddeley Puma and the Sunbeam Arab, believing them to be better suited to mass production, in comparison to the intricate machining required to build the Eagle and its smaller cousin the Falcon. After the War, a Mark IX version of the Eagle was developed for civilian use. Production continued until 1928, and in total 4,681 Eagle engines were built. Time between overhaul (TBO) for later Eagles was around 100–180 hours.

Variants

Note:

Applications

Engines on display

Examples of the Rolls-Royce Eagle are on display at the: One of the two Eagles that powered Alcock and Brown's historic transatlantic flight is on display at the Museum Of Making, Derby.

Specifications (Eagle IX)