The railway block signalling bell code is a system of bell sounds used in Great Britain to communicate between manually operated Signal Boxes in implementing the railway block system. (The bell system is not used in modern power signal boxes, other than to any older adjacent signalboxes.) Each such signal box has a bell circuit to the boxes on either side of it along the line. The equipment consists of a plunger or tapper (rather like a Morse key) which when pressed, rings a single-stroke bell in a neighbouring box. That box similarly has a tapper for communicating back, so boxes have keys each of which rings the bell in a neighbouring box. The bells sound different tones, so that the signalman can tell them apart by ear.

Examples

Although codes varied from region to region, the following shows a few selected standard UK bell codes:

Typical use

These would be used as follows (assuming a simple exchange between two signal boxes on a plain section of line) between two signal boxes A and B. Assume a train is to pass from the block controlled by A to the block controlled by B. This must be agreed and permitted by the signalman in box B. Here is the sequence of bell codes and associated actions: